Troubleshooting; Technical Specifications - Velleman AVMOD16N1 Bedienungsanleitung

b. Auto-scan Mode
If you wish to use several cameras (up to 3 units), you can allow the channels to run in automatic scan mode. Define
a channel for each camera and switch on each channel on the receiver. The scan mode will switch channels each 5
seconds. If you do not wish a camera to be scanned, simply de-activate it by placing the channel switch on the
receiver in to OFF position.
Camera 1
Camera 3

8. Troubleshooting

If you obtain no or a distorted picture, check the following:
• Are the power adapters for camera(s) and receiver correct (voltage) and properly connected?
• Is the monitor or TV switched on?
• Are the appropriate channels selected / switched on or off?
• Is there a microwave oven or other disturbing device in the signal path? If so, switch it off, move it out of the path
or relocate camera(s) or receiver.
• Is the distance between the camera and the receiver greater than the transmission range?
• Is the receiver antenna positioned for optimum reception?

9. Technical Specifications

Camera
Power Supply
Power Consumption
Dimensions (on stand)
Operating Temperature
Image Sensor
Resolution
Lens
Min. Illumination
Wireless weatherproof colour camera: AVMOD16CCN
The information in this manual is subject to change without prior notice.
AVMOD16N1 / AVMOD16CCN_v2
7.5VDC, 200mA (included)
1.3W
100 x 95 x 40mm
0-50°C ; 32-122°F
1/3" colour CMOS
450 horizontal TV lines
8mm
8 Lux
Camera 2
Receiver
Power Supply
Dimensions
Operating Temperature
Total Weight
Reception Range
Video Output
- 4 -
Receiver
7.5VDC, 600mA (included)
112 x 62 x 18mm
0-50°C ; 32-122°F
105g (0.25LB)
up to 90m (300Ft)
1Vp-p 75Ω
VELLEMAN