Milomex Z31037 Bedienungs- Und Sicherheitshinweise Seite 35

Setting training duration:
1. Press the SET button
(time) on the LC display
2. Enter the desired training duration in minutes (1–60) by
means of the UP
10
3. Press the SET button
duration. The desired training duration appears in box T.
Note: if a training duration has not been set, then the
computer measures the training duration automatically.
At the training start the reading is 0. At the end of train-
ing the reading stops automatically.
Note: in order to save the battery, the skipping rope computer
switches itself off automatically after approx. 8 minutes, in
which there has been no rope movement or pressing of any
buttons. You must then enter your body weight (W) and
desired training duration (T) again.
Training:
1. Begin the training. The computer starts automatically.
2. The LC display shows
– the set body weight in box W,
– the remaining / counting training duration in box T,
– the number of skips / rope revolutions in box L
th
(from the 6 skip onwards),
– the calorie consumption in box C.
Note: you hear an acoustic signal as soon as the set train-
ing duration has elapsed and the computer then stops auto-
matically. The current values flash up in the LC display
Note: press the RESET / ON button
body weight and the set training duration, or to reset to the
factory setting.
Preparing for use
, until the figure in the T box
9
flashes.
2
and DOWN buttons
again to confirm the set training
9
to delete the set
11
.
8
.
2
GB/MT 35