Start-Up; Adjusting The Motion Detector; Setting The Lighting Duration; Adjusting The Sensitivity Of The Sensor - LIVARNO LUX DA 20W Montage-, Bedienungs- Und Sicherheitshinweise

Align the spotlight into the
desired direction. For this, you
may need to slacken the lock-
ing screws
7
joint. After alignment, tighten
the locking screws of the hinge
joint again, to ensure a secure
hold.
After the fuse has been inserted
or the fuse panel is switched
on again, your lamp is ready
for use.

Start-up

Adjusting the
motion detector
Depending on the pre-adjustments
of the motion detector
light will switch itself on for a
1
certain period of time as soon as
the motion detector detects move-
ment. These pre-adjustments are
made using the three controllers
on the underside of the motion
detector (Fig. H).
of the hinge
, the spot-
9
Setting the lighting
duration
Turn the TIME rotary control
on the bottom of the motion de-
tector clockwise to increase
9
the duration of illumination. The
lighting duration can be adjusted
within a time window of approx.
5 seconds to 7½ minutes.
Adjusting the sensi-
tivity of the sensor
Turn the SENS rotary control
on the bottom of the motion
detector clockwise to in-
9
crease the sensitivity of the
sensor.
Note: The motion detector
responds to heat radiation.
When outdoor temperatures
are low, it is more sensitive to
body heat than when outdoor
temperatures are warm. Be
sure to regulate the sensitivity
of the sensor over the course
of the year.
Note: Please observe that the
motion detector primarily
16
15
GB/MT 41