Error code
Error message
There is a hardware
F0118
fault.
The temperature in the
F0119
product is too high.
F0130
There is a general error. The blade does not move freely.
Transportation of the product
•
Make sure that the product is safely attached during
transportation to prevent transport damage and
accidents.
•
Always stop the product and disconnect the power
cord before you move the product.
•
Always disconnect the power tool and the power tool
cord before transportation.
Technical data
PP 492
Rated voltage
Max. output, kVA
Rated current, A
Input voltage, V/Hz
Output voltage, V/Hz
Secondary output voltage, V/Hz
Power supply
1- phase outlet, V
Recommended cable area, 32A
Length, m/ft
0-30/0-100
30-60/100-200
60-100/200-300
Effect power generator
967 - 001 - 04.02.2020
Possible faults
N/A.
The product is too hot.
Transportation and storage
Technical data
Possible procedure
Speak to your servicing dealer.
Increase the flow of water coolant. Use
clean water to prevent a blockage in
the water channels. Refer to
data on page 17 for specifications for
water flow, temperature and pressure.
Stop the product and release the
blade.
Storage of the product
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the product in a dry area.
•
Make sure that the temperature is not lower than
-25°C (-77°F) and not higher than 50°C (122°F).
380-480
20
16/25/32
380-480/50-60
340/0-500
24/0-500
3P+PE+N
230
Cable area, mm
6/10
10/8
16/6
Technical
2
/AWG
17