Husqvarna PP 492 Bedienungsanweisung Seite 16

Error code Error message
"TRAVEL MOTOR
F08
OVERLOADED"
"DEPTH MOTOR
F09
OVERLOADED"
F10 "BLADE JAM"
F11 "GROUND FAULT
OR NO SAW
HEAD"
F12 "NON-COMPATI-
BLE SAW UNIT"
F13 "NO CONTACT
CHECK CAN-CA-
BLE"
F14 "NO RADIO CON-
TACT"
F15 "NO DSP RE-
SPONSE"
Troubleshooting - PRIME tools
Error code Error message
There is current over-
F0101
load.
There is high motor tem-
1
FXX08*
perature.
There is low input volt-
F0112
age.
There is high input volt-
F0113
age.
FXX14* Error in the tool temper-
ature sensor.
1
XX: different numbers on different tool that is connected to the power unit.
16
Possible fault
There is current overload
on the travel motor.
There is current overload in
the depth motor.
The blade can not rotate.
There is incorrect ground of
the product/saw or there is
no saw unit connected to
the product.
The incorrect saw unit is
connected to the product.
There is no connection sig-
nal between the power
pack unit and the remote
control.
There is no radio signal be-
tween the remote control
and the power pack unit.
There is internal error in
the power unit.
Possible faults
There is current overload to the
tool in operation.
The motor temperature is too
high.
The input voltage is too low.
The input voltage is too high.
Stop or short circuit in the tem-
perature sensor.
Possible solution
Turn the dial to the 0 position to reset the product.
If the error message occurs again, the diamond
tool is not sharp or the saw carriage is not adjusted
correctly. Clean the rails and lubricate the gears. If
the error message stays, speak to your servicing
dealer.
Turn the dial to the 0 position to reset the product.
If the error message occurs again, the diamond
tool is not sharp. If the error message stays, speak
to your servicing dealer.
Remove the blade from the cut and start the prod-
uct again.
Do a check of the electrical connection to the prod-
uct. Do a check that the saw unit is connected to
the product. If the error message stays, speak to
your servicing dealer.
Connect a compatible saw unit to the product.
Replace the CAN bus cable.
Do a check that the power pack unit is in operation
and that the green light is on. If the error message
stays, speak to your servicing dealer. The product
can be used with the CAN bus cable connected
between the power pack unit and the remote con-
trol.
Speak to your servicing dealer.
Possible procedure
Speak to your servicing dealer.
Increase the flow of water coolant. Use
clean water to prevent blockage in the
water channels. Refer to
ta on page 17 for specifications for
water flow, temperature and pressure.
Refer to the minimum voltage input in
the manual.
Refer to the maximum voltage input in
the manual.
Speak to your servicing dealer.
Technical da-
967 - 001 - 04.02.2020