Maintenance And Cleaning; Troubleshooting - Concept AC7010 Handbuch

EN
3) Connect the 12 V cable to the 12 V power socket in car, or connect power network cable 220-240 V to an alternating
source.
Note: Never connect the car fridge using both connection cables at the same time! Always choose just one
type of power supply!
4) Close the car fridge box fast by snapping the lid back and turning the handle forward. After a short while you may
check to see whether the car fridge works properly.
5) After a certain period of time the temperature inside will go down by a maximum of 20°C compared to the external
temperature.
6) If you are not going to use the appliance, disconnect the cable.
POWER SAVING RECOMMENDATION
• Choose a well aired place, protected from direct sunlight.
• Before storing hot food, let it cool down.
• Do not open the fridge more often or for longer than necessary!

MAINTENANCE AND CLEANING

Clean the appliance inside and outside using a wet cloth from time to time.
Caution!
- Before cleaning, always disconnect the supply cable from the socket!
- Never clean the appliance under running water, do not rinse it or submerge under water!
- Do not use any detergents or hard objects for cleaning, as they may damage the appliance!

TROUBLESHOOTING

Problem
The product does not work, vent
wheel does not rotate, visible from
outside
The ignition is on, and the fridge
does not work. Pull out the plug and
try the following:
The car fridge does not perform
satisfactorily, and the vent wheel
does not rotate.
The car fridge does not perform
satisfactorily, and the vent wheel is
rotating.
AC7010
Possible cause
The cigarette lighter socket is not
receiving power.
The cigarette lighter socket is dirty.
This causes wrong electric contact.
The lighter socket fuse is burnt.
The vent motor is damaged.
The inner ventilator or cooling
element is damaged.
The integrated power supply is
damaged.
Solution
In most vehicles the ignition must
be on in order to give power to the
socket.
If your car fridge plug in the
cigarette lighter socket is too hot,
the socket has to be cleaned, or the
assembly is wrong.
Replace the fuse (5 A).
Only authorized service may do
the repair.
23