Risk Of Injury; Preventing Damage To The Item; Assembly - Playtive Junior IAN 304090 Gebrauchsanweisung

Assembly variation 4:
• Warning. To be used with protective equip-
ment. Not to be used in road traffic.
50kg max.
Assembly variations 1, 2, 3 and 4:
WARNING!
• None of the packaging materials and
fittings are part of the toy itself, and
must be removed for safety reasons
before giving the item to children to
play with.
• Children may only play with the item
under supervision.

Risk of injury!

• Adult assembly only due to small parts!
• The item may only be used by one person at a
time.
• Check the item for damage or wear before
each use. Always check that all fasteners are
tight. The item should only be used if it is in
perfect condition!
• Make sure that the screws and threaded
screws retain their self-locking properties.
• Do not modify the item in a way that might
endanger your safety.
• Always wear suitable protection (helmet, hand
protectors, elbow pads, knee pads and wrist
guards) and shoes!
• Always show consideration for other people!
• Use the item only on suitable surfaces that are
smooth, clean and dry. Keep away from other
traffic users, if possible.
Avoid sloping terrain, stairs and open water.
• Never ride in the dark or when visibility is
poor.
• Do not let your child use the item unsuper-
vised, as children cannot assess potential
dangers.
• Using the item requires skill to prevent falls or
collisions, which could result in injury to the
user or others.

Preventing damage to the item!

• Avoid water, oil, potholes and very rough
surfaces.

Assembly

Assembling the handlebar (Fig. B)
You will need the base (1) and, for the assembly
variations 1, 2 and 3, the round handlebar (2)
and the T-handlebar (3) for assembly variation
4.
Press the pin (2a, 3a) and insert the handlebar
into the base.
Important: Make sure that the handle-
bar locks into place in the base.
Assembly variations 1 and 2 (Fig. C)
Place the seat (4) on the base (1). Make sure
that the holes on the seat and the base are lying
on top of each other.
Insert the short sleeves (6) from above through
the two front holes and secure them from below
with two screws (5).
Insert the long sleeves (7) from above through
the two rear holes on the seat and the rear holes
on the stabiliser (9).
Secure them from below with two screws (5). Put
a screw (8) into the front hole of the stabiliser
and tighten it (Fig. D).
Use the Allen key (10) provided for the assembly
and lock all screws and threads.
Note: The T-handlebar can be used
as a push-along handle for assembly
variation 1.
Press the pin (3a) on the T-handlebar (3) inwards
and insert the T-handlebar (3) into the opening
on the seat (4). The pin (3a) must audibly click
into place.
Assembly variation 3 (Fig. E)
Secure the stabilisers (9) in the rear three holes
with the screws (8) and tighten the screws with
one of the Allen keys (10) provided.
Adjusting the height of the seat
(Fig. F)
The seat can be adjusted to various heights from
approx. 26–32cm.
To do this, loosen the locking screw (4a) and
adjust the seat to the desired height.
Tighten the locking screw again.
GB/IE 11