Walter K620158 Bedienungsanleitung Seite 45

Troubleshooting
Fault
The motor does not
start.
The motor runs but the
drill bit does not rotate
Battery does not charge Battery not fitted
This product was manufactured and tested with care.
In the unlikely event of a fault the machine must be
repaired by an authorised customer service centre.
K620158_Anleitung_D,GB,F,CZ.indb 45
Possible cause
Battery empty
Problem with battery
contacts
Forward / reverse
switch in central
position
Mode selector in
drilling mode
Drill bit not secured
properly
properly
Battery charger
defective
45
Troubleshooting
Charge the battery
Slide the battery in as
far as it will go
Put the switch in
forward or reverse
position
Correct the switch
position
Check whether you
can remove the drill bit
by hand Fit the drill bit
correctly
Slide the battery in as
far as it will go
Replace charger
11.10.16 10:31