Safety Instructions - SW-Stahl S3266 Bedienungsanleitung

COMMISSIONING:
1. Before operation, put a few drops of acid- and resin-free pneumatic oil in the air inlet of
the tool.
2. Before connecting the tool, clean the couplers and hoses by blasting them briefly with
air. Make sure hose and couplers have a sufficient diameter.
NOTE: The diameters of compressed air hoses are usually chosen too small,
never too large!
3. The operating pressure measured under load at the tool air inlet should be 6.3 bar. A
higher pressure means greater wear and can cause damage to the tool. A fall in
pressure to 5.5 bar means extreme loss of power.
4. Good air quality is vital for any pneumatic tool. The air must be clean, dry and
lubricated. The best solution is a complete maintenance unit comprising an air filter,
regulator and oil-fog lubricator which is no more than 6-8 m away from the tool. The
oiler should be set to 3-6 drops per minute (inspection glass). The length of the hose
between tool and maintenance unit should not exceed 8 m.
5. We recommend using a central oiler unit for optimum tool lubrication. Up to 80% oil can
be saved, which also improves the quality of the air inhaled by the user of course, since
no excess oil is expelled to the air.
6. The hammer mechanism of the impact screwdriver should be lubricated lightly after 60
working hours at the latest. Too much grease will impair the power of the impact
screwdriver since the hammer mechanism will become sticky.
7. If the tool is not to be used for a longer period, it must be lubricated thoroughly before
storage. Before re-use, please heed points 1 and 2.
8. Output and direction of rotation are adjusted by turning the lever. Clockwise = arrow to
the right / Anti-clockwise = arrow to the left.
9. Output can be adjusted in three stages for clockwise and one stage for anti-clockwise
direction using the lever.

SAFETY INSTRUCTIONS

1. In the case of a drive square with bore hole, the socket must be secured using a steel
pin and rubber ring. If the drive square is fitted with a spring ring, this must be checked
for sufficient tension at regular intervals and replaced if necessary. A socket which is
not secured as described in the way here can become loose from the tool and cause
damage. For this reason, never allow the pneumatic tool to rev up in idling gear if there
is a socket on the drive.
2. Only use sockets which are suitable for impact screwdrivers.
3. The pneumatic tool should only be used for loosening / tightening screws. Damage
resulting from non-observance of these instructions, improper use or manipulation of
the tool is excluded from warranty claims. We reserve the right to make technical
changes.
4. Those operating the pneumatic tools are not allowed to wear loose clothing and must
have long hair tied back. - ACCIDENT HAZARD
5. Always wear ear protection, safety gloves and goggles.
6. Check hose connections for a firm fit. Do not use any damaged pressure hoses.
www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
S3266