Hardware-Setup; Charging Up The Battery; Installing The Device - Toshiba PX1215E-1NAC Benutzerhandbuch

HARDWARE SETUP
A. Charging Up the Battery
For safety reasons, the battery was partially charged in the factory before
packing. You may want to charge up the battery before using the device.
1. Insert Connector B of the USB Charging Cable into the Battery
Charging Jack.
2. Insert Connector A of the USB Charging Cable into a USB port. When
the battery is charging the Battery Status Light stays on.
3. Wait until the Battery Status Light turns off and remove the USB
Charging Cable. The normal charging time should be 2 to 3 hours if a
dedicated USB port is used. Charging time will be longer if a
non-powered USB hub is used. (Remark B)
4. Repeat Steps 1 to 3 when the battery is flashing. You can keep on using
the device during charging; however, the charging time will be
extended. (Remark C)
Remark B: Use a dedicated USB port or a powered USB Hub for fastest
Remark C: Lithium batteries do not have memory effect and can be
B. Installing the Device
1. Turn on your computer, if it is not already on.
2. Turn on your E-Mouse by pressing down both the left button and the
right button for 10 seconds, if it is not already on. (Remark D)
3. Connect the Dongle Receiver to a USB port. A message "wireless pen
mouse (2.4 GHz)" should appear on your computer screen. Allow the
automatic set up process to complete and the messages to disappear.
(Remark E)
4. Press down the Channel Select Button A on the
once and
Hold down the Channel Select Button B and press down any of
5.
the Mouse Buttons once
Status Light to turn off, the installation is completed.
6. After the first successful installation, your Dongle Receiver and
E-Mouse are permanently matched. You DO NOT need to repeat Steps
4 and 5 even when you take your E-Mouse to a different computer.
Repeat steps 4 and 5 to re-establish the transmission channel
7.
setting when needed.
Remark D: For safety reasons, your E-Mouse was shipped with the power
6
charging.
partially charged.
the Transmission Status Light should start flashing.
turned off. Please turn on the power before using it the first
time.
and release. Wait for the Transmission
Dongle Receiver
User Manual