Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BEFORE FIRST USE
Clean the device as described under the CLEANING AND MAINTENANCE
section.
Follow SAFETY ADVICE.
POWER SUPPLY
1.
Connect the device to a fixed network with voltage supply of 230V~
50Hz.
2.
Every time you connect the power plug ( ( 5) to the socket, make sure that
the lid ( ( 3) is properly locked in place.
3.
The device is ready to be used.
SWITCHING THE DEVICE ON AND OFF
You can switch the device on by pressing the key switch ( ( 1) and switch it off
by releasing it.
Keep in mind that the device cannot be switched on when the lid is not
properly attached.
Always keep the lid closed when the device is in use.
OPERATION
Danger of accidents! The knife must come to a halt before
the lid can be removed.
1.
Should the power plug be connected to a socket, disconnect the plug
first.
2.
The grinding container ( ( 2) and the knife ( ( 2) have to be dry. You can rub
them dry with a cloth.
3.
Fill up the grinding container with a maximum of 60g of coffee beans.
Coffee must not exceed the edge of the container.
4.
Attach the lid and make sure that it is properly locked in place.
5.
Connect the power plug to an appropriate socket.
6.
Hold the motor unit ( ( 4) with one hand.
7.
Press the switch to switch the device on. The device can be switched on
for a m m aximum of 60 seconds (short-time operation = 60 seconds)
and must cool down sufficiently prior to further use (at least 60 seconds).
8.
Coarseness of the coffee powder depends on the time of grinding. Try a
few times to achieve the desired result.
9.
To stop grinding, release the switch and wait until the knife has come to
a halt. Then disconnect the power plug from the socket.
10.
Carefully lift the lid up and put it aside. If you use a coffee box, hold the
device above the box and press the switch, so that the coffee falls out.
8
Werbung
Inhaltsverzeichnis
