Operation - egger EL 1 plus N2 Bedienungsanleitung

egger EL 1 plus N
3.5 Operation of the light unit egger EL 1 plus N
Main switch
• Position: Reverse side of the unit.
• Function: The switch is usually turned on at all times.
During longer breaks switch off the unit.
In-line quick coupling
• Position: Reverse side of the unit.
• Function: Connection of the gas connecting tube.
Three switches for the respective light levels
• Position: Front plate of the unit.
• Function: There are symbols for the different switch
positions. According to the switch position (symbol)
the respective light level is switched on when starting
the timer. The respective control lamp lights up.
Three control lamps for the light levels
• Position: Front plate of the unit (in the switches for
the light levels).
• Function: Indication of the light levels.
Fan switch
• Position: Front plate of the unit.
• Function: The fan is automatically activated by the
timer. This is sufficient for the normal use of the unit.
In case of continuous operation of the unit, position
the fan switch to "ON". In this position the fan works
without interruption.
16
2
2
Gas switch
• Position: Front plate of the unit.
• Function: Starts the gas flow. If the switch is positi-
oned to "ON", the polymerization will be carried out
with nitrogen gas. The respective control lamp lights
up. The gas flow is automatically controlled by the
timer.
Control lamp for gas
• Position: Front plate of the unit (in the gas switch)
• Function: Indicates gas flow.
Gas flow regulator
• Position: Front plate of the unit.
• Function: Regulates the gas flow. When the unit is
operated with gas, the metal ball in the in-side must
be adjusted to a 50 mm position. This is only possible
during operation of the unit since the gas flow is
dependant on light.
Acoustic signal
• Position: In the timer
• Function: Indicates the end of the polymerization
process.
3.6 Program the timer (C)
Adjusting the operating cycle
• Briefly press the button "PROG" (1 x for hour, 2 x for
minute und 3 x for second), this is confirmed by an
acoustic signal.
• The corresponding position on the display flashes.
By using the button (+/-) you can set the desired
value. Within the second and minute mode, the value
can be changed in steps of 10 by pressing the (+/-)
button longer.
• Confirm with the button PROG, the time set then will
be shown on the display.