Troubleshooting - Asus FX-D1161 Kurzanleitung

Connecting network devices
To connect network devices to the switch.
1. Connect one end of the Ethernet cable to an Ethernet port on the back of the
switch. Connect the other end to the Ethernet port on the network device. Repeat
this step to connect additional network devices.
•
•
2. Plug the AC adapter to an electrical outlet, then plug the other end to the power
connector on the back of the switch.
3. The power indicator and active port indicators will light up indicating that the
device is turned ON and in use.

Troubleshooting

This troubleshooting guide provides answers to some common problems that you
may encounter while installing and/or using the switch. These problems require
some simple troubleshooting that you can perform by yourself. Contact your retailer
if you encounter problems that are not mentioned here.
The POWER indicator does not light up.
• Check if the power cable is properly connected to the switch, and to an
electrical outlet with the correct voltage output.
The STATUS indicator does not light up even after an Ethernet cable
is connected.
• Check if the Ethernet cable is properly connected to the switch and to the
network device.
• Ensure that the switch and your network devices are turned ON.
• Check if the Ethernet cable supports your network speed. Ensure that you
are using at least Category 5 cables. You can use lower quality cables if
your network speed is only 10 Mbps.
Q4151_FX-D1161.indb 5
Use Category 5 (CAT5) Ethernet straight-through cables to ensure proper
connection between the switch and other network devices.
The length of the network cables should not exceed 100 meters (328 feet).
Quick Start Guide 5
9/26/08 12:31:35 PM