AEG LAVATHERM 86589IH2 Benutzerinformation Seite 46

46 www.aeg.com
Problem
Err (Error)
on the dis-
play.
No drum
light
Abnormally
elapsing
time on the
display.
Programme
inactive.
Drying cycle
too short.
Drying cycle
too long
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not
operate? - contact the service centre and give the error code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
10.2 Drum internal lamp
This appliance has an internal lamp that
comes on when you open the door and
goes off when the door is closed.
1)
Possible cause
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
Defective drum light.
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
The water container is full.
Too small laundry volume.
The laundry is too dry.
The filter is clogged.
Too high volume of the load.
The laundry not spun sufficient-
5)
ly.
Very high room temperature -
this is not the appliance mal-
function.
Remedy
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
Contact the service centre to
replace the drum light.
The automatic procedure —
this is not the appliance mal-
function.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme. The time value must
be related to the load. To dry
one item or small quantities of
the laundry we recommend to
use short times.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Clean the filter.
Obey the maximum load vol-
ume.
Spin correctly the laundry.
If possible, lower the room
temperature.
WARNING!
Do not look directly into the
beam of the lamp.
3)
,