LED-POL ORO-TESSA Bedienungsanleitung Seite 2

GB
ORO-TESSA
TECHNICAL PARAMETERS
Material: Plastic coated aluminium
Watt: 12W, 18W
Voltage: AC220-240V ~50-60Hz
Work temperature: -20 - 40° C
Driver: Built in
Beam angle: 110°
INSTALLATION DIAGRAM
Open hole
IMPORTANT INFORMATION
Always switch off mains supply before fitting.
Do not cover it with paper or cloth. Take off from flammable materials. Do not use the
luminaire where the ambient temperature is over 45°C. Keeping your eyes with a security
distance, the light could cause damage.
It is recommend that luminaires installed and fitted by a qualified electrican
ensuring the installation complies to the current building regulations.
LED-POL will not accept responsibility for any claims arising from a poor installation.
This product has no user serviceable parts.
Clean with a damp cloth and wipe dry with a cloth or paper kitchen towel.
WIRE CONNECTION GUIDE
L
N
COMPATIBLE WITH:
ORO-FRAME-TESSA
MOUNTING IN A SURFACE-MOUNTED FRAME:
1. Drill mounting holes in the ceiling to mount the frame, according to the position of the
holes in the frame.
2. Screw the frame to the ceiling.
3. Connect the power cord to the light source.
4. Push the light source into the frame until you hear a click.
USER MANUAL
Connect the power.
Pull tabs clips
The brown wire is connected with the L wire of city
electricity.
The blue one is connected with the N wire of city
electricity.
SIZE
12W 166x30 mm
18W 222x30 mm
Do not cover the backside
with anything
Luminaire flush with ceiling
12W 166x35 mm
18W 222x35 mm