Thrustmaster T-Charge Duo NW Benutzerhandbuch Seite 3

RECHARGING A WII REMOTE
1. Connect the USB connector on the T-Charge Duo NW to the USB plug (
Wii™ console or on any other device with a self-powered USB port.
2. Ensure that your Nintendo® Wii™ console (or your device) is in active or standby mode.
(For the Wii™: green LED = active mode, orange LED = standby mode with WiiConnect24 enabled*.
For other devices: please refer to the manufacturer's documentation.)
3. Place your Wii Remote in one of the two dedicated slots on the T-Charge Duo NW, making sure that
the wrist strap does not interfere with the proper positioning of the contacts on the Wii Remote with the
contacts on the T-Charge Duo NW.
The blue LED corresponding to the occupied slot lights up.
When the batteries are completely recharged, the blue LED flashes.
Full charging time for two 900 mAh batteries: 4 hours (for 1 Wii Remote).
Average battery life = 12 to 15 hours, depending on the type of use.
We recommend that you always put the Wii Remote back in its slot in the T-Charge Duo NW when it is
not in use.
For your security, the T-Charge Duo NW is equipped with a heat sensor, allowing you to leave it plugged
in permanently.
*
Please refer to your Wii™'s instructions for information on how to enable WiiConnect24 mode.
2/6
) on your Nintendo®