Changing The Master Code - tau TCODE-W Installationsanleitung

3_ Then press button
together and then briefly press button
green LED will stop flashing.

5. CHANGING THE MASTER CODE

To change the Master code, follow these steps:
1_ Press button A for 4 sec. until you hear a "beep" and the green led starts to flash;
2_ While the green LED is flashing, enter the Master code (if factory = 0000; or the one created by
you).
A
3_ Press button again for 4 sec. until you hear a "beep" and the green LED starts flashing quickly;
4_ While the green LED is flashing quickly enter the new Master code;
5_ Then press button
confirming that the new code has been entered.
6. REPLACING THE BATTERY (fig. 4-5-6)
The TCODE-W digital keypad works using two 3V lithium batteries of the CR 2032 series.
The duration of the same depends on the number of daily activations, in a residential context it
exceeds two years, in a condominium context it will depend on the number of users.
To replace them, it will be necessary to open the keypad as shown in figure 4-5.
B for 4 sec. until you hear a "beep" and the LED starts flashing red and green
B again. At this point, to confirm codes deletion, the red and
B briefly, a "beep" will be heard and the green LED will remain on for a second
7