SANUS VuePoint F35 Montageanleitung Seite 8

2 Mount the Wall Plate
Wood stud
2-1
Locate studs
< 16 mm
(5/8 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[01]
[06]
8
[01]
[05]
Verify the center of the stud(s) using an awl, a thin nail, or an
edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!

Any material covering the wall must not exceed 16 mm (5/8
in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.
(nominal 38 x 89 mm (1.5 x 3.5 in.))
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
75mm
3 in.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage

DO NOT over-tighten the lag bolts [06].

Tighten the lag bolts [06] only until the washers [05] are pulled
fi rmly against the wall plate [01].
13mm 5.5mm
)
(1/2 in.) (7/32 in.
6902-002016 <01>