Technical Service - Hamilton Beach Revolution Bedienungsanleitung

Safety Alert Symbols
The following safety alert symbols are used
throughout this manual to alert you to the
safety hazards described below.
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in death
or electrical shock.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.

Technical Service

For assistance or replacement parts, call our
Technical Service number:
++910-693-4277
www.commercial.hamiltonbeach.com
INSTRUCTIONS FOR PROPER DISPOSAL OF THIS PRODUCT PURSUANT TO THE
EUROPEAN UNION'S DIRECTIVE ON ELECTRICAL WASTE
Please do not dispose of any electrical equipment as ordinary waste. Help conserve natural resources and
protect the environment: when you have finished using this product, please dispose of it at your local waste
colleciton or recycling center in the area reserved for electrical equipment. Contact your local authority to find
the nearest waste collection centre. To remind you to dispose of this product responsibly and separately from
ordinary waste, it is marked with the symbol of a crossed-out trash bin.
Sanitize before first use and after each use with a
sanitizing solution of1 tablespoon (15 ml) of
household bleach per 1 gallon (3.8 liter) of clean,
cool water (60°F/16°C), mixed according to the
instructions on the bleach.
Blender container
1. Fill container with sanitizing solution, replace
cover and filler cap and hold PULSE button for
2 minutes. Empty container.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
3. Immerse cover and filler cap in sanitizing solution
for 2 minutes.
4. Place empty container on base and press PULSE
for 2 seconds to remove any moisture from the
cutter assembly.
5. When ready to use, rinse with clean water.
Ice hopper
Remove the ice hopper cover and lift out the
1.
inner hopper.
Loosen the thumbscrew on the agitator
2.
assembly and lift the assembly up and out
of the shaving pool.
Remove the ice chute by pressing the unlock
3.
button and pulling down.
Wipe the inside of the shaving pool with a
4.
clean soft cloth dampened with sanitizing
solution .
Rinse the ice chute, the agitator assembly and
5.
inner hopper in sanitizing solution, and allow to
air dry. Wipe the shaving pool, shaver blade,
and ice deflector with a clean, soft cloth
dampened with sanitizing solution.
6. Once all parts are dry, reassemble the agitator,
inner hopper, and ice chute by reversing
steps 1–3.
6
Sanitizing
8
GB
3