GPO Darcy Bedienungsanleitung Seite 13

Note: Press STATION- button to lower the radio frequency.
Press and hold this button to activate auto scanning into the lower
frequency ranges.
Press STATION+ button to increase the radio frequency.
Press and hold this button to activate auto scanning into the upper
frequency ranges.
4. Rotate the VOLUME +/- knob button to adjust the volume as
instructed above.
5. Press the STANDBY button again to turn off the unit.
Storing an AM/FM station preset
Your Radio can store up to 10 FM and 10 AM radio stations in its
preset memories for instant access to your favourite stations.
1. Tune the Radio to the AM or FM radio station that you wish to preset.
2. Press and hold the Preset button for approximately 2 seconds until
Pxx is displayed, where 'xx' is the number of the preset (01-10) .
3. Use the STATION +/- button to move to the preset location that you
would like to store the radio station to (01-10).
4. P ress and release the PRESET button to confirm.
Note: If there is already an existing AM or FM station stored under a
preset, it will be over written when you store the new station.
Tune to an AM/FM station preset
In AM or FM mode:
1. Press and release the Preset button. Pxx is displayed, where 'xx' is
the number of the preset (01-10) .
2. Press the STATION +/- button to move to the Preset location and
station that you would like to listen to (01-10). The radio will instantly
tune to that station and begin to play.
13