ISAN MAGIC MIRROR Bedienungsanleitung Seite 6

LED DISPLAY CONTROL
Radiator with installed a unit for control of LED panels and an
integrated display.
DISPLAY
shows: TIME, AMBIENT TEMPERATURE, HUMIDITY.
LED panels
light surrounding according to user setting. Panel BRIGHTNESS
and COLOUR may be changed.
The values displayed are indicative only and are dependent on
the location of the radiator.
CONTROL BUTTONS
ON / OFF button
Button to change indication on display,
entry and incrementing in the "Setup" mode
"Minus" button to decrease
set values or brightness levels
"Plus" button to decrease set values or brightness levels
CONNECTION TO MAINS
The radiator with the LED panel is supplied with 230 V / 50 Hz
with a flexi-cord (1,5 m) with a terminating plug. Insert the plug
into a socket located in position outside the radiator.
DISPLAY
CONTROL BUTTONS
LED PANELS
RADIATOR
SWITCHING LED PANEL ON AND OFF
Procedure:
- switch the LED panel on by pressing a control button
- switch off by repeated pressing the button
SETTING OF TIME, BRIGHTNESS AND
DISPLAY COLOUR
Setting modes:
- setting of hours (24 hours in total)
- display brightness
- LED panel colour in range of 01-90
Entry to the mode "Setting"
Press the button for three seconds
The position "HOURS" starts flashing
Pressing next button
modes are switched in this order:
 HOURS  MINUTES  DISPLAY BRIGHTNESS 
COLOUR OF LED PANEL  SWITCHED OFF
To increase a value, press the "plus" button:
To decrease a value, press the "minus" button:
LED PANEL CONTROL
Basic control modes:
- time indication (24-hour mode)
- surrounding temperature indication [°C]
- humidity indication [%]
- LED lighting brightness [-]
Pressing the button
modes are cyclically switched in this order:
 TIME  TEMPERATURE  HUMIDITY
With the button
LED panel brightness is increased
With the button
LED panel brightness is decreased
Note: LED panel colours may be changed in the mode "Setting"
Before you ask service, you should do:
- If buttons on the display do not react, it is necessary to clean
the control panel from possible dirt.
- In case the display is out of order, it is necessary to restart
electronics by pulling the flexi-cord out of the socket (230 V AC).