ISAN MAGIC MIRROR Bedienungsanleitung Seite 5

Before installation and use of radiators please read carefully this manual and keep it for further use.
Important:

Before deaerating of the radiator always check if the radiator has been disconnected from an outlet. Water penetration inside
the radiator must be avoided, it includes electronics (see page 1).

Maximum temperature of the input media must not exceed a value of 75 °C.

This heating element is determined to heat rooms (e.g. living rooms, bedrooms etc.). Applications in bathrooms are allowed only
in the zone 3; for other zones, i. e. zone 0, 1, 2 it is forbidden (see picture 1). The appliance must be protected by a (differential)
fuse with a 30mA release current.

Installation of the heating element must be carried out professionally and in accordance with up-to-date standards valid in the
country of installation.

Before you start any installation or maintenance, always check, if the main breaker is switched off.

Do not use the heating element before proper and full installation by a company with a professional capability in areas of
electronics and hot-water heating.

Do not switch off the control unit of the heating element by a non-standard break of a supplied cord.

If the supplied cord is damaged, it must be exchanged.

The nominal voltage for the control unit must be the same as the supplied voltage (230 V AC ±10%).

The outlet has to be compatible with the plug of the control unit and it is located in position outside the radiator (see page 1).

Avoid any contact (including evaporation) of the heating element with chemical products based on organic solvents, acids and
chlorine or cleaning agents containing acids or chlorine.

The device should not be used by persons (including children)
-
with a reduced sensation or a mental indisposition
-
persons unskilled or unfamiliar with use of the device (if they are not supervised by a person responsible for
their safety, able to observe instructions in the manual).

Do not allow children to play with the device without any supervision.

Do not insert any metal objects, fingers etc. into the area of control unit connection, even for a short time.

The control unit must not touch a wall or a floor.

To avoid overheating, do not cover holes in the heating element.
Remarks for disposal of this product valid in European Union
A crossed symbol of a dustbin on your product remembers you that in European Union all electric and electronic
products must be collected separately at the end of their life time. Please do not dispose these products as unsorted
municipal waste. Return these products to the collecting places to avoid damage of environment or health injury of
people from uncontrolled waste disposal and to support long-term repeated use of material sources. Information about
collection is available at product salesmen, local authorities dealing with wastes or responsible companies of national
manufacturers.
The manufacturer refuses all responsibility for any incorrectness in this document caused by errors in printing or
translation. He reserves rights to perform any changes on his products that he considers as necessary or useful. This
document or its any part must not be copied, modified or reproduced without any written approval of the manufacture.
Picture 1