Installing The Product - nedis IREX150AT Kurzanleitung

•
This product may only be serviced by a qualified technician for maintenance
to reduce the risk of electric shock.
•
Disconnect the product from the electrical outlet and other equipment if
problems occur.
•
Do not expose the product to water or moisture.
•
Do not open the product.
•
If the power cable is damaged, it must be replaced by a special cable or
assembly available from the manufacturer or its service agent.
•
Only use provided parts.

Installing the product

4
Make sure all the devices you want to connect have been switched off.
1. Plug the IR receiver A
4
When using multiple IR receivers A
avoid interference.
9
4
A
blinks red to indicate a signal is being transmitted.
9
4 A
lights up green to indicate the product is in standby mode.
2. Plug the IR transmitter A
5
3. Place A
near an IR transmitter of your device.
5
4 Only 1 A
can be connected per device.
4
To avoid interference keep the distance between your device and the IR
receiver 10 m apart from each other.
Connecting the power supply
There are multiple options to connect the IR transmitter A
Select one of the following:
• Plug a 12 VDC @ 1 A adapter into the 12 VDC power port A
•
Plug a USB cable (not included) from your device into the 5 VDC USB-A power
4
port A
.
4
The corresponding power indicator LEDs A
F.A.Q.
1. How do I locate the IR receiver of my device?
•
Consult the manual of your device.
•
Move the emitter on the surface of the device until a signal is received from
the remote control.
9
2. Why is A
not responding?
9
into the IR receiver port A
9
, keep a distance of at least 6 meters to
5
into an IR emitter port A
5
8
.
1
.
2
to a power supply.
3
6
lights up.
.