Description And Specifications; Description; Icons - RIDGID HB382 Handbuch

• Hydraulic benders use high pressure fluid to
generate large forces. High pressure fluid can
penetrate skin. Large forces can break and
throw parts, causing serious injury. Stand clear
of the unit during use and always wear appropri-
ate protective equipment, including eye protec-
tion.
• One person must control the work process
and machine operation. Only the operator
should be in the work area when the machine
is operating. This helps reduce the risk of injury.
• Read and understand this manual, and the
warnings and instructions for all equipment
being used with this tool before operating.
Failure to follow all warnings and instructions
may result in property damage and/or serious
injury
• Use the Hydraulic Pipe Bender only with
RIDGID Hydraulic Pipe Bender attachments
as directed in these instructions. Other uses or
modifying the Hydraulic Pipe Benders may dam-
age the tool, the attachments or cause personal
injury.
The EC Declaration of Conformity (890-011-320.10) will
accompany this manual as a separate booklet when re-
quired.
If you have any question concerning this RIDGID® prod-
uct:
– Contact your local RIDGID distributor.
– Visit www.RIDGID.com or www.RIDGID.eu to find
your local RIDGID contact point.
– Contact RIDGID Technical Services Department at
rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.

Description and Specifications

Description

RIDGID® Hydraulic Pipe Benders allow precision cold
bend ing of metallic pipe from
the unit). The tip-up wing configuration of the RIDGID
Hydraulic Bender allows easy access to the pipe for set
up and removal. Benders are available in both manual
and electric versions.
The RIDGID Hydraulic Benders are generally designed to
bend the following types of pipe:
• EN 10255 Medium and Heavy Series
• ASTM A53 Schedule 40 and 80
• DIN 2440, 2441 Series
• BS 1387 Medium and Heavy Series
• GB/3091 (ISO 559) Medium and Heavy Series
/ " to 3" (depending on
1
4
Hydraulic Pipe Bender
Pipe with thicker walls and/or high hardness (over
75 HRb)/strength (over 66 ksi (455 MPa) Tensile) may not
be able to be bent. Pipe with comparable outside diam-
eter and wall thickness to the pipes listed may be able
to be bent depending on pipe material characteristics.
Pipe with thinner walls can be bent but may experience
issues with kinking or buckling in the bend area.

Icons

Do not dispose of electrical
equipment with household
waste
Fill Port
Weight
Cylinder
Bending
Frame
Corner
U-Bracket
Supports
Figure 1 – Hydraulic Pipe Bender 2" and 3" Manual Unit
Figure 2 – Hydraulic Pipe Bender 2" and 3" Electric Unit
Power ON
Power OFF
Pump Handle
Pins
Straightening
Former
Formers
5