Duravit D.1e Montage- Und Gebrauchsanleitung Seite 7

The electrical installation should only be
carried out by qualified electricians.
Explanation of the key words and symbols
DANGER
Indicates a hazardous situation
which will result in death or serious
injury if not avoided.
Technical data
Rated voltage
Frequency
Power consumption in standby
Max. power consumption
Protection class
Circuit breaker
Residual current circuit
breaker RCD
Safety instructions for the electrical
installation
DANGER
Risk of fatal electric shock
> Carry out the electrical installation in
accordance with the national, European
and international directives and standards.
> Switch off the power supply before the
installation.
> Prevent the power supply from being
switched on accidentally. Prevent recon-
nection according to DIN VDE 0105-100.
> Connect the circuit breaker and residual
current circuit breaker (RCD) that
disconnects all phases from the mains.
> If the power supply cable of this unit is
damaged, the power supply cable must
be replaced by the manufacturer, their
Customer Services or a similarly qualified
person.
> Observe the protection zones.
> Do not install the power supply in
protection area 0 or 1.
> Place the socket outside the protection
areas.
> If necessary, install the tap unit in
protection area 2.
220 – 240 V
50/60 Hz
Safety areas in accordance with
< 0.5 W
DIN VDE 0100-701
15 W
IP X4
I = 16 A
N
0
6 0
I ≤ 30 mA
∆N
6 0
0
1
2
0
MAL_57325/19.08.1
7