3M 64396 Bedienungsanleitung Seite 10

Operating the slide valve:
Push the slide valve from inside to the outside
Push the fl ange over the extraction pipes, place the opening of the bag over the edge of the tank.
5.4. Exchanging the plastic emptying bag
Detach the extraction hose, close the extraction opening
Remove the top section. Switch on the motor before placing on the ground so that any falling dust can also be extracted.
Close the emptying bag with a closing band. Carefully remove the fl ange from the extraction opening and close with the fl ange cover provided.
Dispose of the contents in accordance with the statutory provisions.
Clean the tank and accessories with water. Wipe the top section with a damp cloth.
Allow the tank and the accessories to dry.
It is good practice to clean the device on a regular basis ensuring that the ventilation
slots remain free of any debris or contamination.
Clean the level sensors A occasionally.
Clean the level sensors with a soft cloth.
If the extraction output of the unit decreases and is not improved after the fi lter cassettes
(assuming the tank 7 is empty and the paper fi lter bag
Apply the vibration function to the fi lter cassettes
90° in an anticlockwise direction and then press the locking bar
Fold up the hood and lift out the fi lter cassettes
regulations. Insert new fi lter cassettes. Fold down the hood again and exert a little pressure to click it back into position.
If the motor protection fi lter
3M Instruction Manual
75-078_DustExtraction.indd 10 75-078_DustExtraction.indd 10
OPERATION (WET AND DRY EXTRACTION)
, turn by 180° (see marking
1 2
with a plug (pos. a).
8 8
CLEANING
SERVICING
14 has been exchanged), then it is time to exchange the fi lter cassettes
again before exchanging them. Use a coin or another similar object to turn the catch
12
backwards.
4
12 . Immediately seal the removed fi lter cassettes in a dust-proof plastic bag and dispose of as per the statutory
is soiled, remove them and wash under running water, dry and re insert them.
13
) and press from outside through the extraction pipes to the inside again
4
are cleaned,
12
8
.
3
12 .
on the locking bar
5 4
16.03.2010 10:47:43 16.03.2010 10:47:43