LifeAir IonFlow 500C Bedienungsanleitung Seite 5

Cleaning the ion generator, corona needles
and acrylic stand:
Once every two months you should carefully
clean the fragile corona needles. Use the
small brush that is included in the package
and carefully brush away the thin layer of
white lime scale and dirt, which may have
become attached to the needles. Do not
use pressure or water when you clean the
needles.
Clean the ion generator and the acrylic
stand with a damp cloth or sponge. Wipe
clean and rub away any remaining dirt and
dry with a towel. Do not allow the top and
bottom of the ion generator to come into
contact with water and be careful with the
corona needles.
How to remove collector from unit (Sketch
15 page 77):
1. Move the collector upward.
For warranty see www.lifeair.com
Correct disposal of this product: This marking indicates that this product should
not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take
this product for environmental safe recycling.
2. Rotate the hook 180 degrees as per
page 77, from position "a" to "b".
3. Move the collector downward until it is
separate from the ion generator.
4. Clean the collector following the "Clean-
ing the collector" procedure.
5. After cleaning, assemble the collector by
reversing the actions above.
ENGLISH
5