Pelgrim WA205WIT Bedienungsanleitung Seite 41

INSTALLATION
Mounting
44
Against the wall
1. Remove the filters from the extractor hood.
2. Working through the hood, draw the mounting holes (A) and the
holes to secure the hood (B).
3. Drill the holes.
4. Push the wall plugs supplied into the holes.
5. Insert the screws into the 2 mounting holes (A).
NB: screw the screws in until 1 cm is left protruding from the wall.
6. Hang the hood on the 2 mounting screws.
7. Tighten the mounting screws.
8. Tighten the locking screws.
9. Connect the flue pipe to the flue ring.
Below a kitchen cupboard
1. Working through the hood, draw the 4 mounting holes (A), the hole
for the power lead (C) and the hole for the flue (D) on the bottom of
the kitchen cupboard.
2. Drill the holes.
3. Pull the power lead upwards through the hole provided and push
the flue ring through the opening.
4. Screw the hood, through the bottom of the kitchen cupboard, with
the 4 mounting screws. Tighten the screws.
5. Connect the flue pipe to the flue ring.
540
A
B
A
B
c
255
ø 133
d
85
510
a
a
a
256
a
EN 11