Maintenance - Schill FT 350 Montage- Und Betriebsanleitung

Automatic cable rewinder FT / FTE 350
Fitting and operating instructions
INTRODUCTION
All information necessary for a correct assembly to ensure trouble free operation of
the cable reel are described in the present operating instructions. The warranty
given by the manufacturer is only valid if these operating instructions are observed
and adhered to. Terms and conditions are available upon request or at
https://www.schill.de/en/footer/general-terms
Additional user manuals for other product variants can be found at
https://www.schill.de/en/downloads
GENERAL
Automatic cable rewinder provide for a modern power supply of workstations or the
perfect supply of electrical energy for mobile devices The cable is only pulled out
when needed and in the required length. The remainder stays neatly stored on the
cable reel and is protected from contamination and damage. The power connection
is always accessible, but never in the way. The cable length can be easily adapted
to a changing work situation. There is no cable chaos, no tripping hazard anymore.
If the cable connection is no longer needed, a short pull on the cable stopper will
suffice and the cable will roll up neatly. The automatic cable rewinder provides
safety and order.
HANDLING
The coiled cable should be pulled out to the required length against the spring
tension, but please refrain from the use of undue force. The cable is coiled and fixed
in position as described under "LOCKING DEVICE". The cable should never be
pushed in manually. If the cable becomes entangled when winding it onto the reel,
simply pull the cable out again and rewind.

MAINTENANCE

The cable reel does not require any maintenance, due to the excellent antifriction
properties of the plastic axle bearing. However, the cable must be tested in regular
intervals for damages and replaced if necessary.
CONTINOUS OPERATION
The cable reel is designed for manual use in workshops. The standard cable reel is
fitted with a standard available cable. If used for automated applications when a
high degree of mobility is required, the standard applied cable has limitations. A
special cable with a support core should be used in those applications. In order to
ensure a reliable function, the cable lengths must be reduced by at least 1/3. If you
consider automated applications, please contact the manufacturer up-front (see
"CONTACT").
Bedienungsanleitung_FT 350
Schill GmbH & Co.KG, Bruckstrasse 44, 70734 Fellbach
.
or received on request (see "CONTACT").
Seite 14
www.schill.de
ENGLISH
10.03.2020