Releasing Or Removing The Harness - Orbit baby G3 Bedienungsanleitung

26 -
Instruction Manual - Car Seat + Isofix Base


Releasing or removing the harness

□ Loosen the harness by pressing and holding the adjuster strap lock, while pulling out
on the shoulder straps.
□ Release the tongues by pressing the red button on the crotch buckle.
The car seat must always be locked in the car seat base in the rear-facing position
•
when the vehicle is in motion.
Make sure the top of the car seat base and SmartHub are clear of objects and/or
•
dirt before attaching the car seat. Objects and/or dirt on the top of the car seat
base can lead to an improper installation.

Attach and secure the car seat
□ Grasp the car seat firmly by both carry handles Ⓜ. Position the bottom of the car
seat into the SmartHub Ⓕ until you hear and feel a CLICK.
□ Once the car seat is attached into the SmartHub, rotate the car seat until you hear
and feel another CLICK as it locks into the rear-facing position. Tug on the seat from
side to side and pulling upwards a few times to ensure that the car seat is locked
into place.
CHECK that the car seat is locked in position by looking at the rotation indicators
Ⓙ on either side of the car seat base. If either indicator shows red, the car seat is
not locked rear-facing. Re-attach the car seat.
⚠ WARNING ⚠
Death or Serious Injury Can Occur
Group 0 +