Technical Data - OHAUS Scout STX Bedienungsanleitung

EN-2
4. Turn on the balance and enter the balance's sub menu (Menu/RS232) to
configure the parameters as below:
Baud Rate:
Parity:
Stop bit:
Handshake:
5. The Auxiliary Display operates automatically.
If communication is lost, power the balance and the auxiliary display Off and On to
restore the connection with the Auxiliary Display.
AUXILIARY DISPLAY MOUNTING & PLACEMENT
OPTIONS
 Table top placement: The Auxiliary Display may be placed on a flat
surface without additional hardware.
 Direct wall mounting: The Auxiliary Display may be mounted to a wall
using two screws (not included). Select appropriate sized screws that fit
into the holes in the back of the Display.
 Bracket wall mounting/table mounting: Attach the two mounting
brackets. Position the Auxiliary Display where desired on the wall or table.
Note: When installing the mounting brackets, insert round pins into holes in the
back of the display and then slide each bracket to lock into place. Mounting
brackets may be attached in two different orientations to provide optimum viewing
angle.

TECHNICAL DATA

Model
Operating Temperature
Relative Humidity
Altitude
Storage temperature range
Power requirements
Protection
2400
7 none
2
none
15% to 80% at 31°C non-condensing, decreasing linearly to
8-14.5V ~ 50/60Hz 40mA or 8-20V
Pollution degree 2, Overvoltage category II
Auxiliary Display
PAD7
5 °C to 40 °C
50% at 40°C
Up to 2000m
-10 °C to +60 °C
For indoor use only
Mini DIN port
(Round connector)
40mA (min-max)