Honeywell hmt-1 Handbuch Seite 4

Using the HMT-1 with a Hard Hat
To get hard hat clips, visit shop.realwear.com.
1. Hook the hard hat Clips into the HMT-1 band and snap them into place.
2. Slide the clips into the hard hat accessory slots; the HMT-1 band should sit
outside of the hard hat's harness.
3. Put on the hard hat and if applicable, tighten until secure and comfortable.
4. To remove the HMT-1 from the hard hat, pinch the clip fingers and push the clip out of
the hard hat slots.
Using the HMT-1 without a Hard Hat
Attaching the Rear Pad
The Rear Pad snaps
onto the HMT-1's rear
band; align the open-
ings on the Rear Pad
to the pegs on the
HMT-1's rear band,
and snap into place.
During operation, remove the Rear Pad to view
intrinsically safe regulatory information.
A B C D E A F B
Attaching the Head Strap
Insert the end of the
strap into the inside
slot on both sides of
the HMT-1 as shown.
Fold the end back on
itself and
secure using the
velcro patch.
G C H D I E
A
J F G H
B C D
I
E