Force Rs Installation; Force Rs Pc Setup - ACT LABS Force RS Handbuch

installation

Force RS Installation

1. Turn off your computer before connecting your ACT
LABS Force RS.
2. Mount the wheel base to a tabletop or desk using the two
flywheel table clamps.
3. To connect the pedals, plug the pedal connector into the
pedal socket on the back of the wheel base.
4. Insert your Force RS Engine cartridge into the cartridge
slot on the back of the wheel base.
5. Plug the 9-pin serial connector from the cartridge into
an available serial port on your computer.
6. Plug the power supply connector into the Force RS Engine
cartridge.
7. Plug the power supply into an available power outlet.
8. Turn on your computer and continue to set up your wheel
using the Setup CD included. You can also access your
game's menu screens for more wheel options.
NOTE: When you are not using your Force RS, it is recommended
that you unplug the power supply from its power outlet. When
you plug the power supply back into the wall make sure you
reboot your computer to initialize the force feedback.

Force RS PC Setup

Use the Setup CD included in this package to load the Force RS
driver on your computer. Take the steps listed below:
1. From Windows 95/98, in the Start menu, click Settings,
then select Control Panel. From the Control Panel
window, select the Add New Hardware icon.
2. Click Next.
3. Click No, then Next when prompted to search for new
hardware.
4. Select Sound, video and game controllers.
5. Select Have Disk.
6. Insert your Force RS Setup CD into your CD-ROM drive
and specify the disk drive location. For example, type
'D:\WIN9X" if your CD-ROM drive is drive D. Click OK.
7. Follow the instructions on your screen and restart your
computer if necessary.
6