Setting The Stroke Length - Fancom LM.125 Anleitung

LM three phase
1. Open the lid of the reduction gear unit (reductor).
2. Change over the OPEN and CLOSE connection (terminals 3 and 4) of the limit switches.
3. Change over the connections of the inlet position feedback (terminals 2 and 4).
4. Close the lid of the reduction gear unit.
5. Change over the two phases, e.g. U1 and V1.
3.11

Setting the stroke length

Combination overview
The stroke length depends on whether the worm wheel supplied has been mounted or not.
Two different stroke lengths (see technical specifications) can be set on the LM. (Figures below).
The factory setting is without worm wheel.
Without worm wheel 3.0-12.0 rev
Gnd
With worm wheel 1.5-3.0 rev
g
8