Fermax NCITY 1L Installations- Und Benutzerhandbuch Seite 20

Video-set vds

Inhaltsverzeichnis

Kit Video VDS

MONITOR PROGRAMMING

Option 1: From Panel + Monitor

1º. With the monitor connected, press the programming button. A confirmation tone is heard.

2º. Press the house call button. Another confirmation tone is heard.

* The monitor will not work unless it has been programmed.

Option 2: From the Monitor

1. Enter configuration mode: Press the

and a confirmation tone is heard.

2. Set the monitor in programming mode: With the monitor connected, press the programming button

for 1 second.

At this point, the call number currently programmed is indicated by means of high-pitched tones. First,

the Hundreds, then Tens, and finally the Units.

To separate each unit, the LED comes on and a lower tone is heard.

3. Program the call number: Every time the button corresponding to hundreds, tens or units is

pressed, the figure increases by one.

Hundreds: Press the

Tens: Press the

Units: Press the

4. Exit programming: Press the programming button or wait for 30 seconds without pressing any buttons.

When you exit prgramming mode, the number indicated is stored. If it is correct (between 1 and

199), a confirmation tone is heard. If it is not correct, an error tone is heard.

(5 sec.)

Pag 20



< 2 min

button for 5 seconds. The LED blinks once per second

button

Current no:12

moc

beep

moc

If 9 is reached and the button is pressed

again, an error tone is heard. The next

button pressed starts off from number1.

beep

moc

Inhaltsverzeichnis