Video Setup; Aspect Ratio; Video Output - elta 8847MP4 Gebrauchsanleitung

9.2 VIDEO SETUP

Select Video in the setup menu, and display the Video submenu:

9.2.1 Aspect Ratio

4:3: Choosing this setting if your DVD player is connected to a normal ratio TV. You can fill the movie to the entire screen
of your TV. This might mean that parts of the picture (the left and right edges) won't be seen.
16:9: Choose this setting if your DVD player is connected to a wide screen TV. If you choose this setting and you don't have
a wide screen TV, the images on the screen may appear distorted due to vertical compression.
Notes: The image display ratio is related to the recorded disc format. Some disc can not display images in the aspect
ratio you choose. If you play a disc recorded in 4:3 format on a wide screen TV, black bars will appear on the left and
right side of the screen. You must adjust the screen setting depending on the type of the television you have.
9.2.2 View Mode
With this option you can select the different video vision mode on the screen.
9.2.3 TV System
This product supports output of various system, including AUTO, NTSC, PAL.
If your TV set has only NTSC or PAL system, the screen will blink and become colorless when a wrong system is selected. In
this case, press the N/P button on the Remote Control to switch the TV TYPE.
Note: For more information of output format, refer to the instructions or your TV set.

9.2.4 Video Output

Selecting the Video Output setting to switch between different video outputs
Component: Set the video output to interlacing component output.
RGB: Set the video output to SCART output. If you select SCART connection, you should set up the play mode as RGB
state, then it will output normally.
P-Scan: Set the video output to progressive component output
HD: Set the video output to high definition output
Note1: When the player is connected to a TV set of progressive scanning though YPbPr, select P-SCAN. When it is
connected to a common TV set, select Component.
If TV screen has no output after selecting P-SCAN, you can press V-MODE button to switch the state, it will output
normally.
If you select SCART connection, you should set up the play mode as RGB state, then it will output normally.
If you select HDMI connection, you should set up the play mode as HD state, then it will output normally.
Note2: Set video output type to "Component", "RGB" or "P-Scan".
• HD resolution menu should be disabled.
• HDMI should stop working
• HD JPEG mode menu should be disabled.
Note3:Set video output type to HD.
• HD resolution menu should be enabled and set to "Auto" responding to this action.
• "HD/Res." key is valid to switch HD resolution only at this case.
• HDMI module can work only at this case.
• No CVBS at HD resolution
• No OSD and sub-picture at HD-JPEG mode
34
Downloaded from www.Manualslib.com manuals search engine