3.1. Direct impact on the area of projection of
3. SETTing UP THE «AK TOM Mini» APPArATUS
the apparatus «AK TOM mini».
1. Press the built-in oscillator to the selected
area without using the connecting cable.
2. Press the «Mode» button 3 times, LED 1 and
2 lights up at the same time (fig. 5).
3. Press the «Start» button. LED 1 will blink
intermittently and you will hear a chirping sound
(fig. 6).
4. The timing of the procedure is 10 min. After
this time the apparatus will stop chirring and LEDs
1 and 2 lights up. The apparatus will automatically
turn off and the LEDs will go out after 10 seconds.
5. To end a session early, simply press «Start»
again.
6. The impact is selected for each zone indi-
vidually. The total time of exposure to the area of
Fig. 5
Fig. 6
33