Inhaltsverzeichnis
Werbung
IMPORTANT! Th e battery must be in an upright position
during use and while charging. Actual power consumption will
vary according to prescription pressures and breathing patterns.
Th e lower the prescription, the less power required.
NOTE: Th e battery should be fully charged before use to ensure
that the full battery capacity is available.
NOTE: If you are using a heated humidifi er with your therapy
device, the humidifi er will not heat up while connected to
DC power. In this mode, the humidifi er acts as a passover,
or non-heated humidifi er.
NOTE: Th e battery adapter cable accessory, used with the DC
Power Adapter, cannot be used with the Portable Battery Pack.
Connecting the DC Power
Adapter
1.
Turn off the therapy device.
2.
Connect the Auto Adapter to the input cable end of the
DC Power Adapter. See Figure 4.
3.
Plug the Auto Adapter into the battery pack socket.
4.
Plug the DC Power Adapter's output cable into one of
the power receptacles on the rear of the therapy device.
5.
Turn therapy device on, and verify proper operation.
2
3
Figure 4: Connecting the DC Power Adapter
1/5
4
Werbung
Inhaltsverzeichnis
