Perel GIK01 Bedienungsanweisungen

GIK01 / GIK02 / GIK03 / GIK04 – ELECTRIC INSECT KILLER
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the GIK01 / GIK02 / GIK03 / GIK04! If the device was damaged in transit, don't install or use it
and contact your dealer.
2. Safety Instructions
Do not operate this device with open housing.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class II. All other items fall under class I. It is therefore essential that the device
be earthed. Have a qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• The GIK01 / GIK02 / GIK03 / GIK04 should only be connected to an alternating current of max. 230V AC/50Hz.
• Do not use the device in areas with vapours or flammable substances.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Always lead the power cable away from the device.
• All modifications of the device are forbidden for safety reasons.
GIK01 / GIK02 / GIK03 / GIK04
1 PEREL