SOLIS BL3345 Typ 8327 Bedienungsanleitung Seite 75

39. Do not place anything on the appliance while it is in use or
in storage.
40. Pull the plug after every use. Only then, the appliance is fully
switched off.
41. The appliance has to be cleaned after every use. Please refer
to the notes given in the section "Cleaning and mainte-
nance" on page 87 of this manual.
42. Clean the motor unit only with a dry or slightly moist towel.
Never use aggressive, abrasive or acidic detergents for clean-
ing.
43. When lifting or moving the appliance, always touch the
blender by its base. Always disconnect the power plug and
take off resp. empty out the blender jug / blender container.
Always move the appliance very carefully and do not shake
or throw it, it might be damaged.
44. Should you notice a strange smell or sound, switch the appli-
ance off (in case a program is running) and pull the plug. Do
not start using it again before having its functionality and
safety checked by Solis or a service centre authorised by Solis.
45. Never touch the blender blades in the blade base. They are
extremely sharp and could injure you!
46. Before disassembling or cleaning the appliance, always switch
the appliance off with the Power button on the control panel
if it is still blending. Then, wait for the motor and the blades
to come to a complete standstill and disconnect the power
plug from the power socket. This also applies if the appliance
is not in use.
47. After completing a full-length blending cycle (180 seconds),
the motor should be allowed to cool down for 5 minutes
before you restart it. In general, please always let the motor
cool down to room temperature (this takes approx. 2 min-
utes) after two blending cycles before restarting the appli-
GB
75