SW-Stahl 24032L Bedienungsanleitung Seite 6

3 .
Let the residual oil drain, in the following screw
overflow/filling pipe till stop. Assemble and tighten
with 3 Nm.
5 .
Fill the gear oil in the container. Follow the
manufacturer's specifications
7.
Close the outlet valve and "overfill" the
transmission with oil.
9 .
Start the engine, push brake pedal, gear selector in every position each about 3 sec. and then again
put in position „P". Let the engine run. Transmission oil temperature should be about 45 degrees (not
higher). Check transmission oil level again, fill up if necessary.
6
4 .
Connect the matching filling adapter with
the thread of drain pipe.
6 .
Connect the hose with filling adapter
and tighten the clamping screw.
8 .
Open the outlet valve, fill the excess oil return
into the container. Remove the adapter with
tube connection and tighten oil drain plug.
Because of the overfilling excess oil can leak!