Maintenance - Frico Elektra F Aufbau- Und Montageanleitung

period and is stored in a damp environment,
moisture can enter the element. This should not
be seen as a fault, but is simply rectified by
connecting the appliance to the mains supply via
a socket without a safety cut-out, so that the
moisture can be driven out of the element.
The drying time can vary from a few hours to a
few days. As a preventive measure the heater
should occasionally be run for a short time when
it is not being used for an extended period of
time.

Maintenance

The appliance should be cleaned reguarly both
inside and outside, to prevent overheating and
risk of fire but also to guarantee long life of the
heater.
Note! To keep the protection class it is very
important to tighten the screws properly when
the lid is put back again after installation or
maintenance. When the screw has reached the
rubber gasket, continue another 2 1/2 turns.
Safety
• Ensure that the area around the intake and
exhaust grille is kept free from material
which could obstruct the air flow through
the unit!
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with clothes, or similar materials,
as overheating can result in a fire risk!
The guarantee is only valid if the units are used
in the manner intended by the manufacturer
and in accordance with the installation and
maintenance instructions.
Accessories
For fixed installation the heater can be
controlled by an external control panel for start/
stop. ELS can only control one unit. Please note
minimum distance 1800 mm, see fig. 2 page 3.
Type Description
ELS Control panel , start/stop
Elektra F
Dimensions
HxWxD
[mm]
105x70x80
GB
13