Werbung
ASSEMBLY
1. Sort out the different components from each other according to the picture above.
2. Assemble the base (4, 5, 6, 7) and then assemble the front part (1, 2, 5) of the frame including
the crossbar and the L-bend pipes. The push buttons help in securing the pipes into position.
3. The back supports (3) must be assembled after step 2 has been completed.
4. The open end of back support fits into the pipe collar on the rear connectors welded on the
base of the goalpost. The top and front part of the back support must be secured with the L-bend
pipes using the bolt (B). The bolt can be tightened using an Allen Key (included in the kit).
5. Unfasten all the zippers and/or hook & loop connectors on the net.
The zipped sleeves are fitted on the front crossbar and on the rear crossbar of the goalpost.
NOTE:If you are standing opposite the goalpost and facing it from the front, the print on the
net and on the top/front crossbar sleeve must be facing you. Invert the net if this is not the case.
6. The sleeves with hook and loop fasteners sewn on them
wraps around the 2x vertical side supports (on the front)
and the 2x horizontal side supports (on the base) respectively.
7. The Target Wall shall be secured on the front of the goalpost
by meshing the hook and loop fasteners on the wall with
the fasteners on the net.
8. The elastic loops wrap around the radius of the L-bent pipes
and then secured into place using the buttons.
9. The goalposts include a set of ground anchors (8) and a fastener nut (A). Insert the anchor
into the ground through the hole located on the front of the base of the goalpost. The threaded
end of the anchor must protrude out of the goalposts. After doing this, thread in tightly the
fastener nut on the threaded end the protruding anchor.
The goalpost is now ready to use.
www.axi.com
2
B
1
A
7
8
info@axi.com
5
B
3
1
5
4
DerbyRun180
A030.403.00
2
3
7
4
6
date: 10-2015
Werbung
