Cleaning And Care - Hisense RB327N4AD2 Bedienungsanleitung

Cleaning and care

For hygienic reasons the appliance
(including exterior and interior
accessories) should be cleaned regularly
(at least every two months).
Warning!
The appliance must not be connected to
the mains during cleaning as there is a
danger of electrical shock! Before
cleaning switch the appliance off and
remove the plug from the mains socket.
Exterior cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Wipe the control panel with a clean, soft
●
cloth.
Spray water onto the cleaning cloth
●
instead of spraying directly on the surface
of the appliance.This helps ensure an even
distribution of moisture to the surface.
Clean the doors, handles and cabinet
●
surfaces with a mild detergent and then
wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are
●
likely to scratch the surface.
Don't use Thinner, Car detergent,
●
Clorox, ethereal oil,abrasive cleansers or
organic solvent such as Benzene for
cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly.It will be easier to clean when
food stocks are low. Wipe the inside of the
fridge freezer with a weak solution of
bicarbonate of soda,and then rinse with
warm water using a wrung-out sponge or
cloth.Wipe completely dry before
replacing the shelves and baskets.
Thoroughly dry all surfaces and
removable parts before putting them
back into place.
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long.If the frost is too thick,
choose a time when the freezer is nearly
empty and proceed as follow:
1.Remove existing food and accessories
baskets,unplug the appliance from the
mains power and leave the doors open.
Ventilate the room thoroughly to
accelerate the process.
2. When defrosting is completed,clean
your freezer as described above.
Caution!
Do not use sharp objects to remove frost
from the freezer compartment. Only after
the interior is completely dry should the
appliance be switched back on and
plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals to
stick to the cabinet and tear when you
open the door.Wash seal with a mild
detergent and warm water. Rinse and dry
it thoroughly after cleaning.
Caution!Only after the door seals are
completely dry should the appliance be
powered on .
Replacing the LED light:
Warning:The LED light should be
replaced by a competent person. If the
LED light is damaged,contact the
customer helpline for assistance.To
replace the LED light,the below steps can
be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and
out.
3. Hold the LED cover with one hand and
pull it with the other hand while pressing
the connector latch.
4. Replace LED light and snap it correctly
in place.
16