Warranty - Felisatti MF800VE Bedienungsanleitung

NOISE AND VIBRATION
This tool has been designed and made to reduce
noise to a minimum. However, in spite of this, in certain
circumstances the maximum noise level in the place of
work could exceed 85 dBA. In this case, the operator
should wear ear protection.
The machine's noise and vibration levels, measured in
compliance with EN 60745, usually reach:
Acoustic pressure, dB(A)
Sound-power level, dB(A)
Vibration acceleration, m/s
2
Use ear protection!
MAINTENANCE AND CARE
WARNING! Always unplug the machine before
carrying out work on it.
- The machine should be taken to a technical service
centre if the power falls.
- Tool inspection: Using a worn tool will reduce the
efficiency of the work being performed and could lead to
motor damage and the tools should be changed when any
abrasion is noted. Daily: Clean the tool holder.
- Inspect the mounting screws: Regularly inspect all
the mounting screws and ensure they are firmly tightened.
Should any screw be loose, tighten it immediately. Failure
to do so could put you at serious risk.
- Motor maintenance: Take the utmost care to en-
sure that the motor winding is not damaged and does not
become damp with oil or water.
- Brush replacement: Have them replaced by an Official
Service Centre.
- Clean the machine thoroughly after each use with a
blast of dry air.
- The vents of the machine should be kept clear at all
times.
- Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it replaced.
- Use only Felisatti accessories and spares. The parts
the changing of which is not covered in this instruction
manual, should be replaced in a Felisatti Official Service
Centre (See Warranty/Official Service Centre address
leaflet).
Do not dispose of electric tools in
the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.

WARRANTY

See general warranty conditions printed on the
attached sheet.
MF800VE MF1050VE2 MF1200/VE2
86 88.2 92
95 99.2 105
3.1 3.465 4.5
DECLARATION OF CONFORMITY
We hereby declare, under our sole
responsibility, that the FELISATTI brand
products described in this manual comply
with the following standards or standard
documents: EN60745-1:2009, EN55014-
1:2006+A1,
EN61000-3-2:2006+A1+A2,
3:2008 in accordance with EU Directives
2006/42/EC, 2006/95/EC, 2004/108/EC,
2002/95/EC
Jordi Carbonell
We reserve the right to make technical changes 09/2012
EN55014-2:1997+A1+A2,
EN61000-3-
Santiago Lopes
5