Warranty Exclusions - BCS xact Benutzerhandbuch

EN
EYE PROTECTION
All iXS helmets are designed for use with eye protection. The Xact helmet has been
specifically designed for use with goggles. See (FIG. H) for proper goggle fit. It is your
responsibility to obtain and use eye protection.
EPR (EMERGENCY PADDING RELEASE)
WARNING
• The following illustrates the functionality of the Xact EPR system, but should not necessarily be
implemented for all types of injuries and conditions. Consult medical or emergency staff before
removing the helmet of an injured person.
• Xact cheek pads are secured to the helmet using Hook and Loop Velcro fasteners which can be
removed by pulling on the release tabs located on the bottom of the cheek pads away from the
helmet as shown in (FIG. I)
• Reverse order for reinstalling cheek pads
COMFORT INTERIOR LINING REMOVAL/INSTALLATION
The Comfort Interior Lining is attached to the helmet EPS via tabs at
the front and rear of the helmet and may be removed for cleaning
or replacement.
To Install:
• Slide the front and rear side tabs of the liner between the shell
and EPS
• Make sure the liner fits securely underneath the Eye-port Lining
and rear EPS protector.
FIG. H
FIG. I
4
WARNING
Improper placement of the interior comfort lining will compromise the function of the helmet and could result in serious injury or death.
Always make sure the padding correctly positioned and securely fastened before use. Do not use any pads that are not specifically designed
for this helmet and sold by iXS. Aftermarket pads/liners may not fit properly and could cause serious injury or death.
VISOR ADJUSTMENT/REPLACEMENT
To Adjust:
• Loosen the adjustment bolt located under the center of the visor and pivot the visor
either up or down depending on the desired position.
• Hand tighten the adjustment bolt to secure the position.
To Remove:
• Remove the central adjustment bolt by hand and the side screws with either with a
coin or flat head screwdriver.
To Replace:
• Position the replacement visor on the helmet and secure in place by hand tightening
the central adjustment bolt and side screws with coin or screwdriver.
WARRANTY
iXS products is offering a two year warranty. Bring or send your iXS Xact Helmet and the retail seller's original receipt as a proof of the date
of purchase to the retailer where you purchased the item. Any postage, insurance or shipping costs incurred in sending your iXS product for
service under either option above is your responsibility. iXS will not be responsible for products lost or damaged in shipping.

WARRANTY EXCLUSIONS

• Helmets that have been involved in accidents, modified, poorly maintained or used for commercial purposes.
• Damage occurring during shipment of the products (such claims must be presented directly to the shipper).
• Damage to products resulting from improper assembly or repair, the use or installation of parts or accessories not compatible with the
original intended use of the product, or the failure to follow the product warnings and usage instructions.
• Damage or deterioration to the surface finish, aesthetics or appearance of the product.
• Any products for which the consumer does not follow the warranty procedures outlined above.
5
EN