Storage Of Products; Connecting To The Power Supply System - AHT M Serie Bedienungsanleitung

User manual M / MV / CT / CMV

7. Storage of products:

8. Connection to the power supply system:
The manufacturer is not liable for damages or accidents which are a result of misuse, the
non-observance of regulations in the country where the cooling display is applied, power
fluctuations beyond the specification on the data plate, lightning, power outages or any
other acts of nature.
AHT Cooling Systems GmbH – NL Deutschland
Sonntagshornstraße 19 · 83278 Traunstein
Transport damages must be reported immediately after delivery.
Observe the local regulations for the disposal of packing material.
If possible, use the packing material several time and recycle.
Absolutely keep a certain distance to the walls! For this purpose, please
install the supplied wall distance piece at the rear side of the device!
A location "back-to-back" without partition is not
permitted!
Operate the device at a temperature range between +16° C
(61° F) and +26° C (78° F) and at a maximum humidity o f 60% RH!
This device is exclusively suited for the storage and presentation of
packed food or food* filled in bottles or cans
Not suited for open (unpacked) food.
*observe according regulations concerning storage temperatures
Fill the device only up to the maximum line markings.
Do not block internal ventilation grids in front or rear of unit to maintain
proper performance.
The socket must be provided with a correct ground contact.
Voltage and frequency must comply with the information on the name
plate.
If you are not sure whether your installation is correct, have a qualified
technician inspect your electric system.
The supply voltage does not deviate more than +/-10% from the
recommended voltage.
o 220 V / 50 Hz version:
o 115 V / 60 Hz version:
· Germany ·
198 – 242 Volt
98 – 126 Volt
13
Tel. +49/(0)861/209 32-0 · Fax +49(0)861/209 29-90 · Email worldwide@aht.at