H - Cleaning The Suction Filter; I - Replacing The Fuses; L - Wiper Adjustment - Ghibli ROUND 45 E 55 TOUCH Gebrauch Und Wartung

9.1.h - Cleaning the suction filter (Fig.
e floor - Lift the filter with its cover (62).
n the - Loosen the screw (63) and remove the
on the filter (64).
- Wash the filter (64) in running water and
reassemble it in reverse order.
as in-

9.1.i - Replacing the fuses

egee"
open
Replace the blown fuse with one with the
strips
same amperage.
55).
nd re-
- Remove the plug (16 Fig. 8) from the
nside
socket (43 Fig. 8).
- Remove the cover (65 Fig. 19) unscrew-
ing the screws (66 Fig. 19) to access the
fuse.
- Remove the cover sheet and replace the
worn
fuse. Put the cover (65 Fig. 19) back.
ay be
9.1.l - Wiper adjustment (Fig. 20)
- It is possible to adjust the height of the
lades
wiper and adjust the incidence of the
blades on the floor.
verse
Height adjustment (only if necessary)
- The height is adjusted at the time of con-
struction of the machine, then change it
only when absolutely necessary.
ubber - Loosen the screw (67) and lift or lower
the wheel (68) until the wiper is in the
r and desired position, then tighten the screw
anical (67).
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
water
metres, then turn off the aspirator and
stop the machine.
de the
- Check the incidence of the rubber (50)
blades.
he fil-
Fig. A = too low
Fig. B = too high
water
Fig. C = correct position
ening
- Use the grey knob (69) for adjustment,
turning it anticlockwise to increase the
u can
incidence and in the other direction to de-
ver on
crease it.
18)
(Figg. 8-19)
WARNING:
EN-11
EN