B - Electrical Connection; C - Preparing The Machine And Choosing The Cycle; D - Using The Machine - Ghibli ROUND 45 E 55 TOUCH Gebrauch Und Wartung

K

7.1.b - Electrical connection

- Introduce the cable (42) of an extension
in the tear-proff hook (28) locking it as
shown in figure.
- Connect the outlet (43) of the extension
nk at
cord (42) with the plug (16) of the ma-
chine.
- Connect the power cord to an outlet hav-
nnect
ing minimum capacity of 10A.
e oth-
to the
- Make sure that the mains system is
) indi-
equipped with an RCD (circuit breaker).
nspar-
- Unwind the electric power cable com-
pletely before operating the appliance.
nk for
- Use an electrical extension lead only
cal kit.
if in perfect condition; ensure that the
section is appropriate for the appliance
power rating.
- Never let the power cable run over
r the
sharp edges and do not tread on it.
ed by
to the
7.1.c - Preparing the machine and
- Press the switch (34 Fig. 6).
- Release the lever (3 Fig. 9) and lower it;
h the
the floor squeegee (11 Fig. 9) is lowered.
fer to
- Press down on the pedal (19 Fig. 9), re-
ooklet
lease it from its coupling and lift it, the
e de-
brush (10 Fig. 1) will be lowered.
8)
The brush has two working positions;
Normal position "A"
It is automatically placed when you release
of the
the pedal (19 Fig. 9) from the lifted position.
d and
Position for persistent dirt "B"
From the "A" working position, lift the pedal
n the
(19 Fig. 9) and engage it in the "B1" holder;
at the
an additional pressure of 5 kg will be exer-
cised on the brush.
t tube
pports
WARNING:
choosing the cycle (Figg. 6-9)
NOTE:
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- In order to perform the drying cycle alone,
press the switch (35). The suction unit will
activate.
Brushing only cycle:
- To perform only the brushing cycle, press
the switch (38) to enable brush rotation.
Touch the touch sensor to start the rota-
tion of the brush.
Washing, brushing cycle:
- Press the switch (38) to enable brush
rotation, press the switch (39) to enable
water dispensing.
Touch the touch sensor to start the rota-
tion of the brush and the water supply.
Washing, brushing, drying cycle:
- Press the switch (35) to start the aspira-
tor, switch (38) to enable brush rotation
and press the switch (39) to enable water
dispensing.
Touch the touch sensor to start the rota-
tion of the brush and the water supply.
7.1.d - Using the machine (Fig. 1)
- After turning the machine on and se-
lecting the cycle, the cleaning operation
starts, pushing the machine with the help
of the handle (1).
N.B.:
Pay attention to particularly delicate floors;
do not use the machine while it's stopped
and the brush rotation on.
N.B.:
The proper cleaning and drying of the floor
is done by pushing the machine forwards;
if you go backwards the machine will not
perform drying; in this phase, always lift the
wiper to avoid damaging the blades.
EN-7
EN