Optimum Time Ultimate Event Watch Gebrauchsanleitung Seite 3

START
STOP
START
STOP
E v e n t
MIN
MODE
MIN
SEC
SEC
2
Wa t c h
CLEAR
CLEAR
MODE
OPERATING INSTRUCTIONS
TO SET THE TIME
1. Put the timer into clock mode by pressing the "MODE" button. (The clock mode can be recognised
by the flashing colon between the hours and minutes digits and also by either "AM" or "PM" being
visible at the top of the display.
2. Press the "CLEAR" button and hold it down for approximately 2 seconds until the display begins to
flash.
3. Press the "MINUTES" button (marked"MIN") until the correct hour is shown.
Notes a) Each time you press the button the clock will advance 1 hour.
b) Keeping the button pressed in for a couple of seconds will start fast scrolling through the hours.
c) The clock is a 12 hour clock with AM/FM indicator.
4. Once the correct hour is set, press the "SECONDS" button (marked "SEC"). This will alter the
minutes in the same way as the hours were set.
5. Once the correct hours and minutes are set, press the "CLEAR" button one more time and the clock
is set and running. The display will also stop flashing.
TO LEAVE THE CLOCK FUNCTION
1. Press the "MODE" button. This will change the unit from clock to timer mode.
2. Pressing the "MODE" button again will revert to the clock.
3. It is possible to change from clock to timer or timer to clock regardless of whether the timer is running or not.
4. Once in the timer mode there are 2 options: COUNTUP OR COUNTDOWN.
3